Execution time of parallel processor homework

For example, a parallel code that runs in 1 hour on 8 processors actually uses 8 hours of CPU time. The amount of memory required can be greater for parallel codes than serial codes, due to the need to replicate data and for overheads associated with parallel support libraries and subsystems.

Compute Execution time of parallel processor homework total execution time (in time units) for using the fourcore processor to compute the squares of 256 elements in parallel.

The four cores have different speeds. Some faster cores finish the job and may become idle, while others are still busy computing until all squares are computed.

Execution time in a multiprocessor system can be split into computing time. for the routines plus routing time spent sending data from one processor to. another. Consider the execution time and routing time given in the following.

table. In this case, the routing time is an important component of the total time. and the total communication time devided by the total execution time (because part a could be misunderstood to plot this quantity) t comm t tot [11R 1 The dashed line corresponds to the 1D decomposition, the dotted line to the 2D decomposition and the solid line to the 3D decomposition.

The cost of solving a problem on a parallel system is defined as the product of run time and the number of processors. A costoptimal parallel system solves a problem with a cost proportional to the execution time of the fastest known sequential algorithm on a single processor.

a. Are not schedulable under FIFO and have 1 CPU utilization. b. Are schedulable under FIFO and have 90 CPU utilization. Earliest Deadline First (EDF) Task Execution Time Period T1 1 sec 10 sec T2 4 sec 9 sec T3 3 sec 8 sec From the table we can see that the total CPU ut ilization of that system is around 92, meaning it is the pipelined processor, the processor needs to stall until the execution module resolves the outcome of a branch instruction before the processor can fetch the next instruction.

In addition, 20 of the instructions depend on a value generated by previous instruction force these instruction to stall for an average of 2 cycles. Given two sets of parallel execution servers SS1 and SS2 for the query plan illustrated in Figure 81, the execution proceeds as follows: each server set (SS1 and SS2) has four execution processes because of the PARALLEL hint in the query that specifies the DOP.



Phone: (368) 508-6302 x 7376

Email: [email protected]